Electrode Placement; Operating Instructions; Insole Pads; Turn On - Hydas 4509.1.00 Instrucciones Servicio

To use the electrodes:
• Attach the electrode to the lead wire.
• Remove the protective backing from the electrode surface. Do not throw away the protective backing
because it is reused after the treatment session has been completed.
• Place the tacky surface to the prescribed skin area by pressing the electrode firmly against the skin.
To remove your electrodes:
• Lift the corner of the electrode and gently remove it from the skin.
• Apply the protective backing to the tacky side of the electrode.
Caution!
• Before applying the self-adhesive electrodes, it is recommended to wash and degrease the skin, and then
dry it.
• Do not turn on the device when the self-adhesive electrodes are not positioned on the body.
• To remove or move the electrodes, first switch off the device or the appropriate channel in order to avoid
unwanted irritation.
• It is recommended that, at minimum, 4 cm x 4 cm self-adhering based, square electrodes are used at the
treatment area.
• Do not apply to broken skin.
• The electrodes should be discarded when they are no longer adhering.
• The electrodes are intended for single patient use only.
• If irritation occurs, discontinue use and consult your clinician.
• Always remove the electrodes from the skin with a moderate pull in order to avoid injury in the event of
highly sensitive skin.
• Do not pull on the electrode wire. Doing so may damage the wire and electrode.

4.4.2 | Electrode placement

• The placement of electrodes can be one of the most important parameters in achieving success with
therapy.
• Every patient is differing from the responds to electrical stimulation, and their needs may vary from the
conventional settings suggested here.
• Once an acceptable placement has been achieved, mark down the electrodes sites and the settings, so
the patient can easily continue treatment at home.

5 | Operating instructions

5.1 | Insole pads

a
Prepare all kinds of accessories. (as pic. 2)
b
Put your right foot on the front of the insole. Get the White belt to pass through the bottom of insole,
and bond the belt on the instep (the degree of tightness is adjustable). Left foot follow this. (as pic. 3)
c
Insert the electrode wire to the plug fetched out from the insole. Please match the color of the plug
to that of the receptacle. (as pic. 4)
d
Connect the electrode wire to host. (as pic. 5)
Pic 2

5.2 | Turn on

• Before using the device for the first time, you are strongly advised to take careful note of the counter-
indications and safety measures detailed at the beginning of this manual (Safety information). As this
powerful equipment is a powerful equipment not a toy!

5.3 | Operation in the "Power off" mode

• There's no display in the LCD under "Power off" mode.
• In order to turn on the device, device start up into standby mode.

5.4 | Operation in the "Standby" mode

• There are 2 types of therapeutic mode in stimulator:
Pic 3 Pic 4 Pic 5
21