Delivery Contents; Technical Data - Hydas 4509.1.00 Instrucciones Servicio

Aparato de estimulación eléctrica con electrodos para los pies
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57
The PADs does not
attach to the skin.
Cannot feel the
stimulation
The skin turns red.
The skin feels irritating.

9 | Delivery Contents

• Electrical Stimulator Device, 1 piece
• Electrode pad (50mm x50mm), 4 pieces
• Electrode leads with 2 buttons, 2 pieces
• Y-cable for footsoles with (4 plugs), 1 piece

10 | Technical data

Model:
Working voltage:
Battery type:
Channel:
Maximum Amplitude:
Load Impedance:
Power save time:
Working current:
Dimensions:
Weight:
Tolerance:
Electrode detection function:
Operating conditions:
Storage conditions:
24
4) The electrodes cord is broken
The adhesive surface of pad is dirty
1) The pad is not attached close to
the skin
2) The pads are attached
overlapping each other.
3) The Electrode leads is not
connected correctly.
4) The intensity is adjusted too
weak.
5) The batteries are worn out.
6) The adhesive surface of Pad is
damaged.
1) The treatment time is too long.
2) The pad is not attached close to
the skin.
3) The adhesive surface of pad is
damaged.
FDES108
DC 4,5 V
3 x AAA
Dual isolated between output channels
40 V
500 Ohm
appr. 3 minutes
appr. 150 mA
110 x 59.5 x 30 mm
appr. 45 gr without Battery
20% of output intensity
The amplitude level will be reset to 0 when the amplitude level is 1
or greater and an open circuit at either Channel is detected.
a temperatur range from +5°C to +40°C
a relative humidity range of 15% to 93% non condensing
an atmospheric pressure range of 700hPa to 1060 hPa
-25°C without relative humidity control; and to 70°C at a relative
humidity uo to 93% non condensing
4) Replace the Electrode leads
Pad is a consumable. Replace pad with
a new one
1) Attach the pad close to the skin.
2) Attach the pads by not overlapping
them.
3) Connect the Electrode leads
correctly.
4) Turn up the Intensity with the [+]
Dial/Power Button.
5) Replace the batteries with new
ones.
6) Pad is a consumable. Replace the
pad with a new one.
1) Limit the treatment time to 20 to
30 minutes.
2) Attach the Pad close to the skin.
3) Pad is a consumable. Replace the
pad with a new one
• Insole, 2 pieces
• White belt (30cm x 5cm), 2 pieces
• AAA batteries, 3 pieces
• Instruction Manual, 1 piece

Publicidad

Tabla de contenido
loading

Tabla de contenido