System Setup; Current (Analog Outlet Setting); Temp Set (Temperature Offset); Simulation - Orion Echo Manual De Instrucciones

sYsteM setUP

Press E and Up arrow key until "SYSTEM SETUP" menu appears on the display screen

in order to enter system setup. Use up and down arrow keys for running between

menus. Press E key instantly in order to change the setting inside the menu. Press

Left arrow key instantly in order to exit from the menu or use BACK option.

It is the menu where 4 mA and 20 mA calibration of analog output is made. 4mA

and 20mA was entered as initial value. the value can be increased and decreased by

pressing up and down arrow keys after pressing E key. It is saved by long pressing to

E key again or by pressing E key after save option is selected.

Note: This setting is made in factory environment. It should not be changed unless

any technical problem is encountered.

It is used for the cases when sensor internal temperature value is not equal with the

outer environment. For compensation, 0Oc was entered as default value in menu

where you will enter offset value. You can change the value by pressing up and

down arrow keys after pressing E key. It is saved by long pressing to E key again or by

pressing E key after save option is selected.

• It should be used in order to perform an accurate measurement for the cases

where sensor internal temperature value is not equal with the outer environment

temperature value. the sensor's measurement for the temperature difference

between internal environment and the outer environment should be accepted as

the temperature offset value.

this menu is used to test the device to where it is connected. select one of the

LEVEL, cUrrEntor tEMP options by using arrow keys and enter by pressing E key.

change the desired value by pressing E key again and using arrow keys.

It is used to restore factory settings of the device. "system setup" is entered by

pressing E key. E key is pressed after "DEFAULTS LOAD NO" option is made as

"dEFAULts LOAd YEs" by up arrow key. It is asked if you are sure about this process

as "DEFAULTS SURE?". E key is pressed if this process is desired to be performed and

left arrow key is pressed if the process is desired to be cancelled.

 Orion Echo Ultrasonic Level Probe

Tabla de Contenido