Publicidad
13. communication setup
communication is performed in two parts. For the first part which is the Modbus
(standart), press E and down arrow key until you see MOdbUs sEtUP on the screen.
For the second part which is the Hart (optional) it is just after relay setup (see menu
diagram)
13.1 Modbus communication setup
13.1.1. address
Go to this menu by using arrow keys and press E key; you can give a value from 1 to
32 for modbus address by using down ad up arrow keys.
13.1.2. Format
Go to this menu by using arrow keys and press E key; you can change modbus
format as rtU or AscII by using down and up arrow keys.
13.1.3. baud
Go to this menu by using arrow keys and press E key; you can change speed and
parity of rs485 serial communication from 600bps (odd even no parity) up to
38400bps by using down and up arrow keys.
13.1.4. register
Go to this menu by using arrow keys and press E key; you can set the Modbus
register type as "MODICON, "32BIT" or "NORMAL" type by using down and up arrow
keys.
13.2 hart communication settings
13.2.1 hart address
come to this menu by using arrow keys and press E key. You can assign a value from
1 to 32 to the device hart address by using up-down arrow keys.
13.2.2 hart Preambles
come to this menu by using arrow keys and press E key. You can assign Preambles
value greater than 1 to the device by using up-down arrow keys.
13.2.3 hart Fixed current
Come to this menu by using arrow keys and press E key. You can fix current output
by using up-down arrow keys.
Orion Echo Ultrasonic Level Probe
23
Publicidad
Capítulos
