Correction Value; Resistance Measurement; Select Measuring Mode; Measurement Range - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

Ocultar thumbs Ver también para MCR-FLP-D-T-2SP-24:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.3.1.5 Correction value

Entry of a correction (offset) value, by which the measured value will be adjusted. The
value will be added to the measured value. Positive as well as negative correction values
are possible. The entry is always carried out to one decimal point.
Menu <–> Select
Set digit,
Select digit
press key
to accept the selection
Assuming the measured value is 28.45 and the correction value is –1.5, the display
will indicate 26.95 .

5.3.2 Resistance Measurement

Menu <–> Selection
press key
to accept the selection
Also suitable for non-linear resistances

5.3.2 1 Select Measuring Mode

Menu <–> Selection
2 wire
3 wire
4 wire
press key
to accept the selection
4. electrical connections
9
Page 14

5.3.2 2 Measurement range

Menu <–> Selection
0 ... 400 Ω
0 ... 4 kΩ
5.3.2.5 Decimal point
Pt 100 (with stored scaling slope)
5.3.2.3 Display unit
Pt 1000 (with stored scaling slope)
5.3.2.3 Display unit
press key
to accept the selection
5.3.2 3 Display Unit (Pt100, Pt1000)
Menu <–> Selection
Display in °C
Display °F
press key
to accept the selection
5.3.2.4 Correction value (Pt100, Pt1000)
Entry of a correction (offset) value, by which the measured value will be adjusted. The
value will be added to the measured value. Positive as well as negative correction values
are possible. The entry is always carried out to one decimal point.
Menu <–> Selection
Set digit,
Select digit
press key
to accept the selection
Assuming the measured value is 28.45 and the correction value is –1.5,
the display indicates 26.95.
5.3.2.5 Decimal point
16
16
15
15
Page 15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mcr-flp-d-t-2sp-230

Tabla de contenido