Enter The Number Of Scaling Points; Define The First Scaling Point; Define The Second Scaling Point; Alarms/Alarm Outputs - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

5.4.1 Enter the number of scaling points

Menu <–> Selection
Example: 2
Pressing the key
increment the value by one.
After reaching 24 the value jumps
back to 2.
press key to accept the selection
5.4.2 Define first scaling point
Firstly set the input value for the start of
the slope using the respective unit (mA, V)
Than set the display value for the start of
the slope
5.4.3 Define second scaling point
Set display value
5.4.4 Define further scaling points
Additional scaling points will be requested
only, when in section 5.3.1 more than 2
Page 20
will
Menu <–> Selection
Example: –50.00
Select digit
Set digit
press key to accept the selection
Menu <–> Selection
Example: –250.0
Select digit
Set digit
press key to accept the selection
Menu <–> Selection
Example: 20.000
press key to accept the selection
Menu <–> Selection
Example: 300.0
press key to accept the selection
scaling points are defined.

5.5 Alarms/Alarm outputs

One, two or no alarms can be active.
When exceeding Signal on
Alarm 1 Output 1
Alarm 2 Outout 2
5.5.1 Alarm 1/Alarm output 1

5.5.1.1 Alarm 1 off/on

Menu <–> Selection
Example: on
Alarm 1 not active
Alarm 1 active
press the key to accept the selection
5.5.1.2 Mode for Alarm output 1
Menu <–> Selection
Latch mode, Latch signal reset at output 1
➱
Chapter 5.5.1.4
Auto mode
press the key to accept the selection
Alarm a: threshold exceeded
b: below threshold
Output mode "Auto": automatic resetting of output when the
signal falls below threshold, signal set to 0, LED extinguished.
Output mode "Latch": Manual and/or electrical resetting
of signal and LED
LED display
on
on
➱
Chapter 5.5.2 24
23
Page 21