Changing The Scaling Slope (400Ω/4000Ω); Input Range 0; Decimal Point For Displayed Value; Changing The Scaling Scope - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

5.3.2 5 Decimal Point (400 Ω/4000 Ω)
Menu <–> Selection
Please note:
The decimal point is only visual. It influences neither
0.0
the measuring accuracy nor the actual resolution,
0.00
that means for example, shifting 2 digits left results
0.000
in a display in unit of hundreds.
0.0000
After the decimal point is set up, the leading zeros
will be suppressed.
press key to accept
5.3.2 6 Changing the scaling scope (400 Ω/4000 Ω)
Menu <–> Selection
use the current characteristics curve
➱
5.5 Monitoring parameter
Enter or alter scaling scope
➱
5.4 Setting the scaling scope
press key to accept the selection
5.3.3 Input range 0 ... 100 mV DC
Menu <–> Select
press key to accept the selection

5.3.3.1 Decimal Point for Displayed Value

Menu <–> Selection
Please note:
The decimal point is only visual. It influences neit-
0.0
her the measuring accuracy nor the actual resolu-
0.00
tion, that means for example, shifting 2 digits left re-
0.000
sults in a display in unit of hundreds.
0.0000
After the decimal point is set up, the leading zeros
will be suppressed.
press key to accept the selection
5.3.3.2 Changing the Scaling slope
Menu <–> Selection
use the current scaling slope
➱
5.5 Monitoring parameter
Enter or alter scaling slope
➱
5.4 Setting the scaling slope
press key to accept the selection
Page 16
21
18
21
18
5.3.4 Input range –100 ... 100 mV DC, bipolar
Menu <–> Selection
press key to accept the selection

5.3.4.1 Select Decimal Point

Menu <–> Selection
Please note:
The decimal point is only visual. It influences neit-
0.0
her the measuring accuracy nor the actual resolu-
0.00
tion, that means for example, shifting 2 digits left
0.000
results in a display in unit of hundreds.
0.0000
After the decimal point is set up, the leading zeros
will be suppressed.
press key to accept the selection

5.3.4.2 Changing the Range Limits

The given limits for the input range can be
entered as is, or adjusted.
Parameter
Possible range of values
0 ... 100 mV not adjustable 0.0
–100 ... 100 mV –100.00 ... 100.00
If the measured signal falls below or ex-
ceeds the programmed value, then the
display alternates between and
the measured value or between
and the the measured value.
Lower Limit
Menu <–> Selection
Example.: –50,00
Select digit
Set digit
Select digit
Set digit
press key to accept the selection
Parameter
Possible range of values
not adjustable 100.0
–100.00 ... 100.00
Setting values out of the range is not pos-
sible. It is only possible to continue with
the set-up, using the keys, when the
settings are correct.
When the input signal falls below the
value set here, then will be di-
splayed
Under-range: When the input signal falls
below –135 mV, then will be di-
splayed.
Page 17