Reset Maximum Value; Monitor Minimum Value; Reset Minimum Value; Mains Hum Filter - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

5.6.1.1 Reset maximum value

Menu <–> Selection
Example: Yes
cannot be reset
can be reset with the
The MIN value can only be cleared by pressing the red key. In addi-
tion "MIN" must be selected as the display source. In parameter set-
press the key
up "r.MIN" must be programmed as "YES"

5.6.2 Monitor minimum value

Menu <–> Selection
Example: Yes
will not be monitored
will be monitored and stored
press the key to accept the selection

5.6.2.1 Reset minimum value

Menu <–> Select
Example: Yes
Cannot be reset
Can be reset with the key
The MAX value can only be cleared by pressing the red key. In addition
"MAX" must be selected as the display source. In parameter set-up
"r.MAX" must be programmed as "YES"
press the key to accept the selection

5.7 Mains Hum Filter

To reduce the interference from mains line and the environment (mains hum), the instru-
ment must be set to the local mains frequency.
Menu <–> Selection
local power line 60 Hz
local power line 50 Hz
press the key to accept the selection
Page 26
key.
➱
5.7 , 26
.

5.8 Setting Default Values

The user has the possibility to set all pa-
rameters back to their default values by
using the parameter . This pa-
rameter must be programmed
with the value =07049. If you
then proceed to the next parameter using
Menu <–> Selection
Select digit
Set digit 07049
press the key to accept the selection
5.9 End of Setup yes / no ?
Menu <–> Selection
Parameter will be stored-> Operation

Check/alter Parameters

press the key to accept the selection
5.10 Check/Alter Parameters
Menu <–> Selection
Checking the individual menu items
• after every 2 seconds the menu changes
to Selection
• If the setting is as desired, then switch to the next menu with
key , otherwise, start the set-up again.
the keys, then all parameters are reset to
their default values. It is not necessary to
finish the programming; a new program-
ming cycle can take place immediately.
➱
5.11, 28
Page 27