Reset Latch Signal At Output 2; Select Signal Form For Output Threshold 2; Min/Max Value Acquisition; Monitor Maximum Value - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

5.5.2 Alarm 2/Alarm output 2
5.5.2.1 Alarm2 on / off
Menu <–> Selection
Example: on
Alarm 2 not activated,
Alarm 2 not activated, press the
5.5.2.2 Mode for Alarm output 2
Menu <–> Selection
Example: on
Reset Latch mode, Latch signal at output 2
➱
Chapter 5.5.2.4 ,
Auto mode
press the key to accept the selection
5.5.2.3 Hysteresis for Alarm 2
Set switching on hysteresis ∆a for Alarm 2
Menu <–> Selection
Select digit
Set digit
press the key to accept the selection
Set switching off hysteresis ∆b for Alarm 2
Menu <–> Selection
Select digit
➱
Set digit Chapter 5.5.2.5 select signal for output 2
press key to accept
Page 24
➱
Chapter 5.6, 25
key to accept the selection
25

5.5.2.4 Reset Latch signal at Output 2

Menu <–> Selection
Manual reset with red key
Alarm output can only be reset manually if
is selected..
Electrical reset with MPI-Input
Alarm output can only be reset electrically, if
is selected as the function and is displayed.
Note: The Display Hold funktion is off.
Both, manual and electrical reset
Alarm output can either be reset manually via the red key or via a reset pulse
press the key
on the MP input.
to accept
Note: The Display Hold function is off.
5.5.2.5 Select signal form for output 2
Menu <–> Selection
Positiv output signal
Output is activated, when the instantaneous
value > limit 2
Negativ output signal
Output is deactivated, when the instantaneous
press the key to
value > limit 2.
accept

5.6 MIN/MAX value acquisition

The maximum value may be captured, saved and consulted during operation
by pressing a key.
5.6.1 Monitor maximum values
Menu <–> Selection
Example: Yes
will not be monitored
will be monitored and stored
press the key to accept the selection
or
,
or
,
➱
5.6.2 , 26
Page 25