Resetting The Min/Max Value; Display Hold - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

Ocultar thumbs Ver también para MCR-FLP-D-T-2SP-24:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.2 Setting the Alarms during Operation
When an alarm value is shown in the dis-
play, its set value can be changed.
Alarm 1 is displayed. LED 'Pr1' is
illuminated
Set Alarm
Display
Action
Select digit position and
set digit.
Example: 300.0
press the
key to accept and go to Alarm 2
Alarm 2 is displayed. LED 'Pr2' is illuminated
Set Alarm
Display
Action
Select digit position and
set digit.
Example 800.0
press the
key to accept the selection
6.3 Resetting MIN/MAX value
Resetting is only possible if this has been
enabled in the parameter mode.
Page 30
Note: the "key-lock" should not
be enabled.
Select Min/Max value display
• press the red key.
• the stored value is cleared

6.4 Display Hold

The Display Hold function is only available
for use with the current measured value
and for the totalizer value.
For as long as a high level signal
( > 4 V DC ) is present at the MP input,
The Display Hold function is only active with
the following parameter settings:
Parameter
Alarms
Alarms
Output Mode
Alarms
Output Mode
Reset-Alarm-Latch
then the display is "frozen".
The MIN/MAX capture, alarm monitoring
and totalizer functions continue in the
background.
Settings
/
/
/
/
/
/
Page 31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mcr-flp-d-t-2sp-230

Tabla de contenido