Instructions For Assembly - Invacare Flo-tech PT Instrucciones De Colocación

Flo-tech PT Harness Range
Fitting Instructions

INSTRUCTIONS FOR ASSEMBLY

STEP 1—Remove the Harness and
components from the packaging
Figure 1
STEP 2—Should this product reach you in
an unsatisfactory condition, please contact
the supplier.
Figure 2
STEP 3—Align the holes in the top tri slot
mounting plates of the Harness (see fig. 1)
with screws attaching the L-Bracket to the
Back Shell (see fig. 2).
STEP 4 - Attachment can also be made to
the wheelchair frame, by means of the
Universal Mounting Clamps, which are
suitable for round tube frames of 19mm,
22mm, and 25mm (see fig. 3). This is the
recommended fixation method for the
bottom straps.
Figure 3
It is recommended that all screws be
tightened to 8.5Nm.
Optional Strap risers (H) are installed at top
of Back Shell L-Bracket using screws (G).
Adjusting the straps
STEP 5 – Pull or loosen strap ends to
adjust the harness position, ensuring that
the harness is firmly fitted (see fig 4).
Always fit in conjunction with a pelvic belt.
4