Dash Disassembly; Kit Preparation - Metra 95-5704 Instrucciones De Instalación

Ford econoline 1992-1996
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DASH DISASSEMBLY

1. Remove the knob from the headlight
switch by releasing the metal tab on the
back of the knob securing it to the shaft.
Unscrew and remove the bezel behind it.
2. Remove (2) T-20 Torx screws in the
instrument cluster area. The screws are
facing up. (Figure A)
3. Remove the trim panels to the left
and right of the steering column, then
remove (2) T-20 screws exposed from
each side. (Figure A)
4. Slide the cup holder out, then remove
(2) T-20 screws exposed. (Figure A)
5. Remove (3) T-20 Torx screw securing the
lower steering column trim panel, then
unclip and remove.
6. Unclip, unplug, and remove the entire
dash panel. (Figure A)
7. Using Metra's 86-5618 radio removal
tools (sold separately), release the radio
from the dash. Slide the radio out, then
unplug and remove the radio. (Figure B)
Continue to Kit Preparation
2
(Figure A)
(Figure B)

KIT PREPARATION

Attention! The factory radio will not be able
to be reinstalled into the vehicle after these
steps have been performed.
To the factory dash panel:
1. Place the cut template over the radio
opening from the factory dash panel.
(Figure A)
2. Using a scribe tool or silver marker, mark
the lines to be cut.
3. Remove and discard the cut template,
then cut the dash. (Figure B)
4. Attach the radio trim panel to the dash.
(Figure C)
Continued on the next page
(Figure A)
Remove shaded area
(Figure B)
(Figure C)
|
386.257.1187
MetraOnline.com

Publicidad

Tabla de contenido
loading

Tabla de contenido