Kit Assembly - Metra 95-5704 Instrucciones De Instalación

Ford econoline 1992-1996
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KIT PREPARATION
Dash modifications:
5. Cut the sub-dash to allow room for the
aftermarket radio (See detail). Leave the
metal radio support brace in until the
point that it must be removed. Leaving
that in while cutting will support the
sub-dash. (Figure D)
Continue to Kit Assembly
(CONT.)
Remove
shaded area
Detail
(Figure D)
Leave plastic
corner piece
intact
Leave plastic
corner piece
intact
1. Secure the radio brackets to the radio
using the screws supplied with the
Unit
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra. Test
the radio for proper operation.
3. Slide the radio assembly into the dash.
Pre-drill the (4) screw holes using a 1/8"
drill bit, then secure the assembly using
(4) Phillips screws provided.
Note: The dash may be very brittle, so
drill slowly.
4. Reassemble the dash in reverse
order of disassembly to complete the
installation.

KIT ASSEMBLY

(Figure A)
REV. 7/19/2021 INST95-5704
3

Publicidad

Tabla de contenido
loading

Tabla de contenido