Worx Jawsaw WG329E Manual Original página 16

PREPARE YOUR JAWSAW
WARNING!
• Read and understand all instructions.
Failure to follow all instructions listed
may result in electric shock, fire and/
or serious personal injury.
• Sharp moving blade. To prevent
accidental operation, ensure that
the battery pack is removed before
performing the following operations,
failure to do this could result in
serious personal injury.
CAUTION: Sharp moving blade.
Always wear protective gloves
when installing or removing the chain,
the Saw Chain (8) is sharp and can cut
you when it is not running.
WARNING:
• Never operate a JAWSAW
damaged or improperly adjusted or
that is not completely and securely
assembled.
16
• Be sure that the saw chain stops
moving when the power control
system triggers are released.
• Never adjust the guide bar or saw
when battery pack is connected .
SWITCHING ON AND OFF
The Trigger Switch (2) is locked to prevent
accidental starting.
There are two Lock Out Buttons (3), to
allow upright (cutting down from the top)
or inverted (cutting up from the bottom)
operation.
To switch on, press either Lock Out Button
with your thumb and squeeze the Trigger
Switch (See Fig. N).
To switch off, just release the Trigger Switch.
CUTTING
Check oil level window (14) prior to starting
and regularly during operation. Refill oil when
oil level is low.
If operating with a newly replaced Saw Chain
(8), check the chain tension around every 10
minutes during operation.
Always hold the Front Handle (4) firmly when
Cordless Limbing and Trimming Chain Saw
FOR USE
®
that is
®
cutting (See Fig. O1, O2)
1. Use both hands to grip saw firmly. Always
use your left hand (I) to grip the front
handle and your right hand (II) to grip the
Rear Handle(1). Thumbs and fingers must
wrap around saw handles (See Fig. O1,
O2).
IMPORTANT: Make sure your
2.
footing is firm and stable. Do not
use the JAWSAW
of branches or while standing on a ladder.
HINT: When cutting branches which are
lying on the ground, place one foot on the
branch to prevent limb from moving (See
Fig. P).
WARNING! Do not put your foot in
the Jaw teeth, keep your foot a safe
distance from the tool. (See Fig. P)
3. Position the tool with the Jaw placed over
the desired branch to be cut.
WARNING: DO NOT force the cut.
Let the Saw Chain pull through the
wood.
WARNING: When starting the saw
make sure the chain is not in contact
with the limb or branch to be cut.
4. Switch on the tool.
5. Push the Rear Handle towards the Front
Handle to complete the cut.
6. Switch off the tool after the Guide Bar and
Saw Chain have returned to their starting
position.
WARNING:
• When completing the cut (step 6 above)
do not push the handle forcefully, let the
spinning chain pull itself through the
wood.
• Using too much force on the rear handle
when cutting can overload the tools
motor.
CAUTION: At the end of each cut be
prepared to support the tools weight.
TRIMMING BRANCHES:
Before cutting any branch, you must consider
the following:
1. Is the branch heavy, will it damage
anything when it falls?
• Large branches should be cut in small
sections starting at the farthest end from
the tree.
while standing on piles
®
EN