Brita MAXTRA Manual De Instrucciones página 16

14
FIRST USE AND CARTRIDGE EXCHANGE
Please see illustrations on page 3
Illustration 1
Wash the lid, jug and funnel in warm soapy water.
Do not use any abrasive cleaners. Note:
The jug and the funnel may be washed in the
dishwasher. The lid must not be washed in the
dishwasher.
Illustration 2
To prepare your BRITA filter cartridge, please
remove protective wrapper (note: cartridge and
inside wrapper may appear moist, this is simply
condensation). Immerse cartridge in cold water
and shake it gently to remove any air bubbles.
The filter is now ready for use.
Note: As is required for some other water filter
cartridges, there is no need to pre-soak the new
Maxtra cartridge.
Illustration 3
Place the cartridge into the funnel and push
downwards until it 'clicks' firmly into place. The
cartridge should stay in place if the funnel is
turned upside down.
02_GA Universal_14SP_en.indd 14 02_GA Universal_14SP_en.indd 14
Prozessfarbe Cyan Prozessfarbe Cyan Prozessfarbe Magenta Prozessfarbe Magenta Prozessfarbe Gelb Prozessfarbe Gelb Prozessfarbe Schwarz
Illustration 4A
Instructions for filling a BRITA Water Filter jug
featuring a pour through lid (with automatic
filling mechanism).
If you have purchased a BRITA Water Filter jug
featuring a pour through lid with automatic filling
mechanism please read the following instructions
regarding steps A1 to A3.
A1
Place the lid back onto the jug and press it
carefully downwards to ensure it fits correctly into
place.
A2
To fill the jug with cold water simply place the
jug under the tap with the opening positioned
directly under the tap outlet to achieve optimum
performance.
A3
Turn the tap on and fill the funnel through the
opening in the lid. The water pressure will
automatically open the pour through mechanism.
(Note: Do not open the tap fully as high water
pressure from the tap can cause splashing.)
Prozessfarbe Schwarz PANTONE 287 PANTONE 287
As the funnel fills up the opening will gradually
close until it reaches the maximum level. As the
opening begins to close you should start reducing
the water flow and eventually close the tap when
the opening closes. You can watch the water level
in the funnel rising through the transparent side
of the jug. There is no need to take off the lid of
the jug to refill the funnel. Every time you want to
filter your water simply turn on the tap and use the
automatic filling mechanism in the lid.
Allow the water to filter through. Please proceed
to step 5.
27.05.2005 9:02:12 Uhr 27.05.2005 9:02:12 Uhr