Kit Assembly - Metra 99-7882B Instrucciones De Instalación

ISO DIN radio provisions
1. Factory screws can be used, or using the nine #8 x 3/8" pan head Phillips
screws, attach the climate controls, hazard, and vent removed in disassembly
to radio trim panel. Use the three #4 x 3/8" truss head Phillips screws to mount
the factory lower trim panel to the radio trim panel. (Figure A)
Metal clip locations
Plastic clip
locations
(Figure A)
99-7882B

Kit Assembly

2. Attach the three metal and three
plastic panel clips. (Factory clips can
be used in place of the metal clips,
but not the plastic clip locations)
(Figure A)
3. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied.
(Figure B)
4. Slide the radio between the radio
brackets and secure with screws
supplied with the radio. (Figure B)
5. Mount the radio/bracket assembly to
the radio trim panel with four of the
Plastic clip
location
screws supplied in this kit. (Figure C)
6. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
7. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly using
the two supplied #8 x 1/2" pan head
Phillips screws for the lower
radio mounts.
3
(Figure B)
(Figure C)