Sauder Harbor View 414941 Instrucciones De Montaje página 13

Step 9
Insert the dowel end of four TWIST-LOCK® FASTENERS (10F) into the ENDS (A and B) as shown. Follow the enlarged
å
diagram closely.
NOTE: If you already pushed the TWIST-LOCK® FASTENERS into the large holes in the UPPER BRACE (E), pull the
å
FASTENERS back out of the holes. Pull at the front and back edges, slowly working the FASTENERS out of the holes.
Push the UPPER BRACE (E) onto the TWIST-LOCK® FASTENERS in the ENDS (A and B). Now, tighten the
å
TWIST-LOCK® FASTENERS.
Carefully turn two FOOT SCREWS (23F) a few turns into the BOTTOM MOLDING (J).
å
Next, turn a FOOT (Q) onto the other end of each FOOT SCREW (23F). Turn the FEET clockwise until the FOOT SCREW
å
is tight in the BOTTOM MOLDING (J) and each FOOT.
NOTE: Do not overtighten the FOOT SCREWS.
å
B
Q
23F
www.sauder.com/services
E
B
J
Q
E
S u r
f a c
T W
I S T -
F A S
T E N
414941
Push the UPPER BRACE (E) onto
the TWIST-LOCK® FASTENERS.
O
e w
i t h
L O C
K ®
E R S
A
Page 13