Publicidad
Step 13
Carefully stand your unit upright.
å
Position your unit in its fi nal location. We recommend using the SAFETY STRAP (60M) for added stability.
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR (61M) into a wall stud. If you prefer to fasten the SAFETY
å
STRAP (60M) to a wall stud, go to your local hardware store for proper hardware.
INSTALLATION INSTRUCTIONS: (Also available at www.yl-anchors.com)
å
1. Insert the SAFETY DRYWALL ANCHOR (61M) through the WASHER (13M) and one end of the SAFETY STRAP (60M).
2. Using a Phillips screwdriver or a hand drill, press screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
Insert the other end of the SAFETY STRAP (60M) through the upper opening in the back of your unit, then use a BLACK
å
9/16" LARGE HEAD SCREW (1S) through the SAFETY STRAP and into the pre-drilled hole in the underside of the TOP.
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR (61M) from your wall.
å
The nylon sheath will remain behind your wall.
To insert the drawers into your unit, tip the front of the drawers down and drop the glides on the drawers behind the glides
å
on the unit. Lift the front of the drawers up and slide them into the unit
30 lbs.
www.sauder.com/services
20 lbs.
20 lbs.
H
G
G
G
I
BLACK 9/16" LARGE HEAD SCREW
414941
13M
61M
60M
1S
(1 used in this step)
Page 17
Publicidad
