Publicidad
Step 14
To make adjustments to the drawers, loosen SCREW #3 in the SLIDES a 1/4 turn, then turn the CAM clockwise or
å
counter-clockwise. Notice how the drawer raises or lowers as you turn the CAM. The higher the screw in the oblong hole,
the higher your drawer front will be. The lower the screw, the lower the drawer front. By adjusting the drawers this way, it
will help the DRAWER FRONTS line up better when closed. Tighten the SCREW when fi nished with adjustments.
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. To clean your unit, dampen a cloth with tap water and wipe.
å
And to celebrate, why not share your success story?
Loosen screw #3 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #3.
The higher the screw in the oblong hole, the
higher your drawer front will be. The lower
the screw, the lower the drawer front.
Page 18
Cam
414941
www.sauder.com/services
Publicidad
