Sauder Harbor View 414941 Instrucciones De Montaje página 9

Step 5
First, fasten the SKIRT (M) to the BOTTOM MOLDING (J). Use two BLACK 1-7/8" FLAT HEAD SCREWS (2S).
å
Then, fasten the BOTTOM MOLDING (J) to one of the LOWER BRACES (D). Use four BLACK 1-1/8" PAN HEAD SCREWS (9S).
å
Fasten the MOLDING (O) to the UPPER BRACE (E). Tighten three TWIST-LOCK® FASTENERS.
å
BLACK 1-7/8" FLAT HEAD SCREW
(2 used for the SKIRTS)
www.sauder.com/services
Rounded edge
2S
Finished surface
O
E
D
S u r
T W
F A S
J
U n fi
n i s h
s u r
e d
f a c
e
M
9S
BLACK 1-1/8" PAN HEAD SCREW
(4 used for the BOTTOM MOLDING)
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
These surfaces should be even.
414941
These holes
must be here.
f a c
e w
I S T -
i t h
L O C
T E N
K
®
E R S
®
FASTENER
Dowel end
Page 9