Publicidad
Step 10
The tabs should insert freely into the
1
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D30
Groove
Insert the DRAWER SIDES (D30 and D31) at an angle into
å
the slot at each end of the LOWER DRAWER FRONT (I).
3
Minimum
190 degrees
P
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (P) to the LOWER
å
DRAWER FRONT (I). Tighten one HIDDEN CAM.
Page 14
I
D31
Maximum
Arrow
210 degrees
I
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
U n
s u
D30
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D945) into the grooves
å
in the DRAWER SIDES (D30 and D31) and LOWER
DRAWER FRONT (I).
4
D30
P
Fasten the DRAWER BACK (D171) to the DRAWER SIDES (D30
å
and D31) and DRAWER BRACE (P). Use five BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
Repeat this step for the other drawers using the DRAWER
å
FRONTS (G). The small drawer will use the SMALL DRAWER
FRONT (H), SMALL DRAWER SIDES (D24 and D25), and
SMALL DRAWER BACK (D170).
414941
D945
fi n
i s h
r f a
e d
c e
I
D31
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(25 used in this step)
D171
D31
www.sauder.com/services
Publicidad
