Package Contents - DeWalt DC390 Manual Del Usuario

E N G L I S H
• Remove the blade changing spanner from the
saw blade locking screw before switching on.
• Do not switch off before the saw blade is running
freely.
When sawing
• Remove all nails and metal objects from the
workpiece before starting work.
• Do not attempt to saw extremely small workpieces.
• After switching off, never attempt to stop the saw
blade by pressing against the side of the blade.
• Never put the saw down on a table or work bench
unless it is switched off and the blade has
stopped running.
• Always use the riving knife, except for inserted cuts.
Operational protection devices
• The circular saw must only be used for cutting
wood or plastic.
• Ensure that all devices screening the saw blade
are in perfect working order.
• Never jam the saw blade guards.
• Free a jammed saw blade guard immediately and
do not use the saw if the guard is jammed.
• Do not remove the riving knife, except when
plunge cutting.
• The riving knife should be correctly set; the
distance between the toothed rim and the riving
knife should be 5 mm and the height difference
should be 5 mm or less .
Checking and changing the saw blade
• Do not use blades with a body thickness greater
or a width of tooth smaller than the thickness of
the riving knife.
• Only saw blades conforming to the specifications
contained in these operating instructions may be
used.
• Saw blades made of high alloy, high speed steel
(HSS steel) should not be used. Good results are
achieved using carbide-tipped or CrV saw blades.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent saw
blades should be discarded and replaced at once.
• Ensure that the saw blade is securely fixed and
rotates in the correct direction.
26
Applications
• When using a saw bench ensure that the width
of the sawing gap is sufficient to take the saw
blade being used.
• When cutting narrow workpieces (width less than
80 mm) longitudinally, use a rip fence guide along
the longitudinal edge.
• When sawing with the workpiece clamped tight,
devices should be used to prevent the workpiece
kicking back.
• When sawing circular sections of wood use a
device to hold the workpiece steady on both
sides of the saw blade to prevent slipping.
• Ensure that pieces of wood sawn off the
workpiece cannot be caught up by the teeth of
the saw blade and thrown in the air.
Guard against kickback
• Kickback occurs when the saw begins to stall
rapidly and is driven back towards the operator.
Release the switch immediately if the blade sticks
or the saw stalls.
• Keep the saw blades sharp.
• Support large panels near the cutting area.
• Use a fence or straight edge guide when ripping;
do not force the tool.
• Do not remove the saw from the work during a
cut while the saw blade is rotating. Release the
on/off switch and wait for the saw blade to come
to a halt.

Package contents

The package contains:
1 Cordless circular saw
1 Saw blade
1 Allen key
2 Battery packs, NiCd (DC390KA)
2 Battery packs, NiMH (DC390KB)
1 Charger (DC390KA/DC390KB)
1 Kitbox (DC390KA/DC390KB)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.