Maintenance And Service; Troubleshooting - Enerpac WFT 71 Hoja De Instrucciones

MAINTENANCE AND SERVICE

Maintenance is required when wear and/or leakage is noticed. Occasionally inspect all
components to detect any problem requiring service and maintenance. Enerpac offers
Repair Part Kits for equipment maintenance. Repair Part Sheets are also available.
Contact your Enerpac representative.

TROUBLESHOOTING

Problem
Plunger will not advance completely when system
pressure is activated.
Work support raises part off of rest surfaces.
Work Support plunger is slipping.
Plunger will not retract.
Plunger will not release to extended height.
Work support leaks oil.
Possible Cause
Determine if hydraulic system is exceeding maximum
flow rate (see specifications table).
Check for broken take up spring.
Check plunger and sleeve for damage.
Work support may be over–size for application.
Hydraulic pressure may be below minimum amount to
hold plunger.
Cutting forces may be exceeding the capacity of the
work support.
Hydraulic pressure has not been released from the
system.
Excessive back pressure from small diameter tubing or
tight bends.
Check plunger, sleeve, and wiper for damage or debris
accumulation.
Check for broken return spring.
Check seals for wear or damage.
Connection to work supports may be leaking.
7