BH H9158 Manual De Instrucciones página 5

FITTING THE BATTERIES.-
This monitor uses 3 volt ALKALINE
BATTERIES. To fit the batteries,
remove the rear cover on the monitor,
Fig. 1, and carefully insert the two
CR2032 type batteries into the battery
compartment (A) making sure that the
battery's polarity is correct (matching
the battery's «+» terminal with the «+»
sign inside the battery compartment,
and the «-» terminal with the «-» sign).
Close the cover, as shown in Fig. 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically if
motionless for 4 minutes.
Important. Discarded batteries must
be deposited in special containers,
Fig. 2.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
displaying the date and temperature.
SETTING THE DATE.-
After inserting the battery, the time
value will flash. Press the SET key to
adjust the
MODE/RESET key to move on to the
year, use the SET key to adjust. Use
the MODE/RESET to move on to the
the unit remains
value. Use
English
day, use the SET key to adjust.
Press MODE/RESET to go back to the
function display.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous
distance, exercise time and calories
burnt.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
A. SCAN FUNCTION.-
In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display
DISTANCE, CALORIES values every
6 seconds.
2. Press the MODE key and this will
cancel the SCAN function.
B. DISTANCE FUNCTION.-
This function counts up or down in
steps of 0.5 km/ml, up to a maximum
of 99.5 km/ml.
Pressing the MODE key for more than
the
two seconds will reset all of the
values.
1. Press any key to switch the monitor
on.
5
read-outs of
mode the
TIME, SPEED/RPM,
speed,
computer