Before Returning For Repairs; Specifications - Schumacher Electric SC4 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
The BAD BATTERY LED is
lit and the CHARGING LED
is flashing.
The BAD BATTERY LED
is lit.

14. BEFORE RETURNING FOR REPAIRS

If these solutions do not eliminate the problem, or for more information
about troubleshooting, contact customer service for assistance:
or call 1-800-621-5485, Monday-Friday 7:00
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP
UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number
from Customer Service at Schumacher Electric Corporation.

15. SPECIFICATIONS

Input Voltage ..................................................................................120V AC @ 60Hz, 3.6A
Output Voltage ........................................................6V or 12V, with auto voltage detection
Output Current Rating ..............................................2A DC @ 6V DC; 15A DC @ 12V DC
POSSIBLE CAUSE
The battery voltage is still
below 10V (for a 12V battery)
or 5V (for a 6V battery) after
2 hours of charging.
(or)
In maintain mode, the output
current is more than 1.5A for
12 hours.
Desulfation was
unsuccessful.
The battery is sulfated.
Lack of progress is detected
and battery voltage is below
14.2V (for a 12V battery) or
7.1V (for a 6V battery).
The battery's initial voltage
is below 12.2V (for a 12V
battery) or 6.1V (for a 6V
battery) and the total input is
less than 1.5 Ah.
The battery voltage drops
to below 12.2V (for a 12V
battery) or 6.1V (for a 6V
battery) in Maintain Mode.
services@schumacherelectric.com
www.batterychargers.com
• 10 •
REASON/SOLUTION
The battery may be defective.
Make sure there are no loads on
the battery. If there are, remove
them. If there are none, have the
battery checked or replaced.
The battery may be defective.
Have battery checked or replaced.
The charger is in desulfation
mode.Continue charging for
several hours. If not successful,
have the battery checked.
The battery may be overheated.
If so, allow the battery to cool.
The battery may be too large
or have a short circuit. Have
battery checked or replaced.
The battery capacity is too low,
or the battery is too old. Have it
checked or replaced.
The battery won't hold a charge.
May be caused by a drain on the
battery or the battery could be
bad. Make sure there are no loads
on the battery. If there are remove
them. If there are none, have the
battery checked or replaced.
to 5:00
CST
am
pm

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Duralast dl-8d

Tabla de contenido