Operation; Before First Use; Turning On; Turning Off - Gaggenau VR 414 610 Manual De Instrucciones

Operation

Before first use

Bear in mind the following instructions before grilling
for the first time:
1 Thoroughly clean the appliance and accessories.
2 Remove lava stones from the plastic film and place
them in the lava stone trough.
3 Fold both grill heating elements down. The grill
heating elements must lie flat.
4 Put on the wire racks and heat up the grill to level
12 for a few minutes. This eliminates potential
contaminants and smells of newness.

Turning on

Note: The two grill heating elements can be regulated
separately. This allows you to grill food with different
temperature requirements at the same time.
1 Press in the control knob and turn it to the required
grill setting. If you do not want to fry on the entire
grilling zone, turn on the front or the rear grill
heating element only.
2 The illuminated rings behind the control knobs flash
fast as long as the appliance warms up. The
illuminated rings light up constantly once the set
grill setting has been reached. For grill setting 12,
the preheating phase takes about 15 minutes.
3 Do not put food on it until preheating is complete.

Turning off

Turn the control knobs to the 0 position.
9
WARNING
Risk of burns
Heat builds up when the appliance cover is
closed. Let appliance cool down prior to closing
the cover. Never switch on the appliance with the
cover closed. Do not use the appliance cover to
keep food warm or as a surface for placing
objects on it.

Residual heat display

The illuminated rings behind the control knobs flash
after turning off as long as the appliance is too hot to
safely touch it.

Overheating protection

In the event of overheating, the appliance automatically
turns off the grill heating elements in order to protect
the countertop and cabinets. After the appliance has
sufficiently cooled down, turn it back on.

Working with the cast roaster pan

The cast roaster pan is especially suitable for preparing
chopped or liquid foods, vegetables, egg dishes and
desserts.
The cast roaster pan is placed on the rear grill heating
element after removing the wire rack. You can prepare
other grilled food on the front wire rack at the same
time.
You can obtain further case roaster pans from your
specialist dealer as special accessories (large or small).
Note: Leave the lava stone trough with the lava stones in
the grill while working with the cast roaster pan.
How to grill with the cast roaster pan
1 Remove the rear wire rack.
2 Carefully place the cast roaster pan on the rear grill
heating element.
3 Turn the control knob for the rear grill heating
element to level 12. Pre-heat the grill until the
heating-up signal goes off.
4 Lightly coat the cast roaster pan with oil and place
the food on it that you wish to grill.
11