geberit ACO 203XL Manual De Instrucciones página 30

EN
Radio interface function
The pressing tools with the type designation "plus" are equipped with a Bluetooth® radio
interface. When used together with a mobile end device (iOS or Android) and the NovoCheck-
App (www.novopress.de), the following functions are available:
• reading out data, such as the number of pressing operations, tool status, serial number, etc.
• checking the tool electronics
• setting the pressing point light and the time until the idle state
• creating construction site reports
To establish a connection between the pressing tool and an end device, the pressing tool must
be ready for operation (tap the start button, green LED lights up, blue LED flashes) and the
NovoCheck-App must be installed on the end device. The blue LED lights up when the
Bluetooth® connection is successfully established.
The blue LED goes out if it was not possible to establish a connection to the end device before
the first pressing operation. The pressing tool must be completely switched off and on again
before establishing a connection can be reattempted. The rechargeable battery must also be
removed briefly.
30
45035998181011211-1 © 02-2018
968.240.00.0 (01)