Migatronic FOCUS TIG 200 PFC Guida Rapida página 4

11
4
5
2
10 12
18
15 16 17
13 14 9 7 8
1 Welding current/Arc voltage
Press the key and turn the control knob
to set the welding current.
Press the key for 3 seconds to display
the arc voltage (valid ONLY for TIG
DC and MMA DC). Press again "A" to
display the welding current.
2 Welding voltage
The LED shines when there is voltage
on MMA electrode or TIG torch.
3 Parameter units
The LED shines when the relevant
parameter unit is active.
4 Overheating indicator
The LED shines when the machine is
overheated.
5 Mains error
The LED shines if the mains voltage is
too high or too low.
3
6 Welding process
Choice of MMA/TIG.
1
7 Trigger mode
Choice of 2-stroke/4-stroke.
8 Current adjustment
Choice of torch adjustment.
6
9 Ignition method
Choice of HF/LIFTIG ® ignition.
10 Gas pre flow (time)
11 Slope down
Time from welding current to stop
amp.
12 Gas post flow (time)
13 Pulse
Key activated = pulse.
14 Pulse setting
Press the menu key until the LED shines
at:
• Pulse time: Welding current period.
• Pause time: Base current period.
• Base current: % of pulse current.
QUICKGUIDE FOCUS TIG 200
15 Current type
Choice of AC or DC welding.
16 AC-t-balance, time-based
Time balance between positive and
negative half-wave is adjusted in %.
17 AC-electrode preheating
Automatic electrode preheating.
18 Choice of secondary parameters
Opens parameters 10, 11 and 12.
PFC