Assembly & Operating Instructions - SKF THKI 300 Instrucciones De Uso

3.1 Assembly & operating instructions
• Screw the high pressure pipe into the G
• Check the oil level in the oil reservoir from the position of the piston handle. Ensure
there is enough oil for the complete operation. Place the oil injection set on a flat
surface. The spring loaded oil reservoir allows the injector to be used in any position.
Close the release valve on the injector (hand-tight is sufficient).
• Ensure that no air is trapped in the system, by pumping until air-free oil is released
from the end of the high pressure pipe. Thread the swivel nipple, on the high
pressure pipe, in to the application. If necessary, use any of the connection nipples
that are delivered with the set.
• Continue pumping until the required pressure is reached. To ensure that you do not
exceed the maximum recommended pressure of 300 or 400 MPa (THKI 300 and
THKI 400 respectively), check the pressure gauge.
• Once the component has been mounted/dismounted, open the release valve to allow
the oil to drain back to the oil reservoir.
• Unscrew the oil reservoir after using the oil injector. Drain the oil from the reservoir
and replace back on the oil injector.
NOTE:
In the event that oil leaks from under the underside of the block, this indicates that the
ball on the high pressure pipe has not been seated correctly. Release pressure and
remove the high pressure pipe. Inspect the ball of the high pressure pipe for damage.
If damaged then replace the high pressure pipe.
If undamaged, refit the high pressure pipe carefully and tighten sufficiently.
8
/ hole in the front of the injector assembly.
3
4
SKF THKI 300 / THKI 400