J.P. SELECTA RE-610 Manual De Instrucciones página 43

1）RE‐610 motor installation
Install the motor kit on the fixing frame (21) to make the motor axis and stirring paddle coaxial, tighten universal
coupling (3). Adjust the height of the motor fixing frame (21) to make the gap between the lower of the stirring
paddle and the vessel bottom >30mm, fix the fixing frame (21). Tighten the fixing nut (30) to fix the stirring paddle.
Figure 2.2.4.3
Connect support frame (39) and motor tray (2), tighten the connection screw. Install the motor kit on the fixing frame (21)
to make the motor axis and stirring paddle coaxial, fix the universal coupling (3). Adjust the position of fixing frame (21) to
make the gap between bottom of the stirring paddle and vessel bottom >30mm, fix the fixing frame (21). Then tighten the
connecting bolt and screw on the lower position of the support frame (39). Adjust the fine‐tuning components (23) to
make the level of the motor tray is horizontal. Tighten the fixing nut (30), fix the stirring paddle.
2.2.5 Nozzle and condenser installation
Please install it according to figure 2.2.5.
Figure 2.2.5
RE‐610 motor installation
Nozzle and condenser installation
1 Motor
2 Motor tray
3 Universal coupling
21 Fixing frame
23 Fine‐tuning components
37 Fixing pole
39 Support frame
19 Condenser
40 Flat washer
41 Nozzle
42 Nozzle nut
43