Problem Solution; Environmental Protection - Worx WX160 Manual Original

tool until the temperature is in the optimum
temperature range again.
14. PROTEcTION AGAINST DEEP
DISchARGING
The Li-Ion battery is protected against deep
discharging by the "Discharging Protection
System". When the battery is empty, the
machine is switched off by means of a
protective circuit: The inserted tool no longer
rotates.

pROBLEM SOLUTION

1. why DOES ThE DRILL NOT TURN ON
whEN yOU PRESS ThE SwITch?
The forward/reverse rotation control, which
is on top of the trigger, is positioned in the
lock function. Unlock the forward/reverse
rotation control by putting it into the required
rotation position. Push the trigger and the
drill will start to rotate.
2. ThE DRILL STOPS BEFORE ThE
ScREw IS cOMPLETELy TIGhTENED.
why?
Verify the torque position of the torque
adjusting ring, you can find the torque-
adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 23 is the
highest torque (screw driving force). Position
24 is for drill operation. Regulate the torque
adjusting ring to a higher position to reach
the best result.
3. REASONS FOR DIFFERENT BATTERy
PAcK wORKING TIMES
Charging time problems, as above, and
having not used a battery pack for a
prolonged time will reduce the battery pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws
into hard wood will use up the battery
pack energy faster than lighter working
conditions. Do not re-charge your battery
pack below 0 C and above 45
o
affect performance.
Lithium-Ion cordless drill/driver
MAINTENANCE
Your tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working
controls free of dust. Occasionally you may
see sparks through the ventilation slots. This
is normal and will not damage your power
tool.
ENVIRONMENTAL
pROTECTION
Check with your local authorities or retailer
for recycling advice.
C as this will
o
Waste electrical products must not
be disposed of with household waste.
Please recycle where facilities exist.
13
EN