Problem Solution - Worx WX100L Manual De Instrucciones

TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING, HAMMER
DRILLING
OPERATING THE ON/OFF SWITCH
WARNING: Do not operate
for long periods at low speed
because excess heat will be produced
internally.
LED LIGHT INDICATOR (See Fig. G)
To turn on the light, press the on/off switch and make sure
the forward/reverse rotation control is on right/left position.
When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed
area. LED is also a battery capacity indicator. It will flash when
power gets low.
The tool and battery pack are equipped with a protection
system. When the LED Light is quickly flashing and turn off,
the system will automatically cut off power to the tool to
extend battery life. The tool will automatically stop during
operation if the tool and/or battery pack are placed under
one of the following conditions:
• Overloaded: The tool is operated in a manner that
causes it to draw an abnormally high current. In this
situation, release the Trigger Switch on the tool and stop the
application that caused the tool to become overloaded. Then
pull the Trigger Switch again to restart.
• Overheated: Under the condition above, if the tool does
not start, the Tool and Battery Pack are overheated. In this
situation, let the Tool and Battery Pack cool before pulling the
Trigger Switch again.
• Low battery voltage: The remaining Battery capacity is
See Fig.F1,
too low and the tool will not operate. In this situation, remove
F2, F3
and recharge the Battery Pack.

5.PROBLEM SOLUTION

See Fig. G
(1) WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.Check that the battery is charged and
properly connected to the tool.
(2) THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring.
Find the torque adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque (screw driving
force) and position 20 is the highest torque (screw driving
force). Position is for drill operation. Regulate the torque
adjusting ring to a higher position to reach the best result.
(3) I CAN NOT FIT THE BATTERY PACK INTO THE
BATTERY CHARGER. WHY?
The battery pack can be inserted into the charger only in
one direction. Turn the battery pack around until it can be
inserted into the slot. The charger LED indicator should
turn on when the battery pack is charging.
17