Disassembling Of The Lift; Checking The Service Light - Invacare Birdie Manual Del Usuario

1. Open the carabiner A by first twisting the safety catch
B and then pressing it backwards with one hand.
2. Hold the safety catch in the open position and attach
the hanger bar C to the carabiner with the other hand.
3. Release the safety catch and move the hanger bar to
the lowest point of the carabiner.

4.5 Disassembling of the lift

1. Remove optional leg spreader handle if attached.
2. Lower the boom and narrow both legs completely.
3. Activate the emergency stop button and apply castor
brakes.
4. Remove the pipe pin and the motor piston from the
boom, reinstall the pipe pin in the piston end, and lock
the motor into the clips on the mast.
5. Attach the hanger bar into the welded fork on the mast.
6. Remove the locking pin from the base of the mast,
release the safety latch, lower the mast, and relocate
the locking pin into the mast near the suspension axle
of the mast.
1575480-E
The lift can now be located in the packaging box, pulled on
the rear wheels, or parked in an upright position with the
mast/boom assembly pointing upwards.

4.6 Checking the service light

( Jumbo Care control unit only)
CAUTION!
– Each time the lift is assembled, and before
using the lift, the service light should be
checked.
– The service light should only be reset by a
qualified technician and must never be reset
by untrained personnel.
A
1. Examine the control box A to see if the service light
C is flashing.
2. When service light is not flashing, the lift is ready for
use.
When service light is flashing, refer to the table:
Setup
C
15