Other Functions
You can also control an optional CD or MD
unit with the rotary commander.
Labelling the rotary
commander
Depending on how you mount the rotary
commander, attach appropriate the labels as
shown as shown in the illustration below.
L IS T
M O D E
S O U N D
Using the rotary
commander
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
TUNER n CD n MD*
* If the corresponding optional equipment is
not connected, this item will not appear.
Pressing (MODE) changes the operation
in the following ways;
• Tuner : FM1 n FM2 n MW n LW
• CD unit : CD1 n CD2 n ...
• MD unit : MD1 n MD2 n ...
Tip
When the POWER SELECT switch is set to position
B, you can turn on this unit by pressing (SOURCE)
on the rotary commander.
By rotating the control
(the SEEK/AMS control)
Rotate the control and release it to:
•Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
S O U N D
•Tune in stations automatically. Rotate and
M O D E
hold the control to tune in a specific
L IS T
station.
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorised on the
number buttons.
(MODE)
•Change the disc.
21