Fein MShy649-1 Manual De Instrucciones página 18

3 41 01 079 06 0.book Seite 18 Montag, 15. März 2010 11:24 11
en
18
Original instructions Straight Grinder.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
An exposed surface is very hot if touched and therefore dangerous.
Additional information.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Confirms the conformity of the power tool with the directives of the European Community.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Ø Diameter of a round part
Grinding accessory (DIN ISO 603, DIN EN 12413) form 4 – Double-sided conical grinding
T
wheel
U
Ø = max. diameter of grinding wheel
D
Ø =Diameter of mounting hole
H
T/U=Thickness of the grinding wheel
Weight according to EPTA-Procedure 01/2003