Kit Assembly - Metra 95-6549 Instrucciones De Instalación

KIT PREPARATION
To the 95-6549 radio/climate control panel:
6. Clip in the a/c vents.
7. Clip in the cigarette lighter/switch panel.
8. Attach the (2) panel clips.
9. Clip in either the storage pocket or dummy
panel to replace the factory ashtray.
10. Secure the tray to the radio climate/control
panel using the (2) #8 x 3/8" Phillips
pan-head screws provided. (Figure C)
11. Grind down the climate control panel
locater pins. (Figure D)
12. 1997-1999: Place the climate control
spacers onto the back of the climate
control panel, then secure the climate
control panel back to the vehicle using
the (4) #8 x 5/8" pan-head screws screws
provided. (Figure E)
2000-2002: Secure the climate control
panel to the 6549 panel using the (4)
#8 x 3/8" Phillips pan-head screws
provided.
Continue to Kit Assembly
(CONT.)
(Figure C)
(Figure D)
(Figure E)

KIT ASSEMBLY

1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or Axxess.
Test the radio for proper operation.
3. Secure the radio assembly to the dash
using (1) factory screw in the top right.
Drill an 1/8" hole in the (3) remaining
screw holes in the brackets, then use the
(3) #8 x 1/2" Phillips truss-head screws
provided to fully secure the radio.
4. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
REV. 8/5/2021 INST95-6549
3