What To Do If - Zanussi ZWI 71000 WA Manual De Instrucciones

Ocultar thumbs Ver también para ZWI 71000 WA:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• screw the pump cover again and close the
door.
Important! Every time you drain the water
through the emergency emptying hose you
must pour 2 litres of water into the main wash

What to do if...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
red pilot light of button 5 blinks to indicate that
the machine is not working.
It is possible to recognize the fault machine by
the number of button 5 light flashes. If the num-
ber of flashes is different from the ones indica-
ted below, this is related to a fault that you can
not solve. In this case, contact your local Serv-
ice Centre.
Press simultaneously the buttons 4 and 5 for a
few seconds. The red button 5 light will flash
for a short time as described (the green flash is
not to be considered) :
Problem
The washing machine does
not start:
www.zanussi.com
compartment of the detergent drawer and then
run the drain programme. This will activate the
ECO Valve device avoiding that part of the
detergent remains unused at next washing.
• 4 flashes = «The washing machine does
• 1 flash = «The machine does not fill»,
• 2 flashes = «The machine does not
Once the problem has been eliminated, press
the button 5 to restart the programme. If after
all checks, the problem persists, contact your
local Service Centre.
The door has not been closed (the button 5 red light blinks).
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme selector dial is not correctly positioned and the button 5
has not been pressed.
• Please turn the selector dial and press the button 5 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
not start», follow the corresponding sug-
gestions in «Possible cause/Solutions» box
and restart the programme.
follow the corresponding suggestions in
«Possible cause/Solutions» box and restart
the programme.
empty and/or does not spin», follow the
corresponding suggestions in «Possible
cause/Solutions» box and restart the pro-
gramme.
Possible cause/Solution
17

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido