Installation - Zanussi ZWI 71000 WA Manual De Instrucciones

1)
Water supply
Maximum Load
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.

Installation

Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
After removing all the
packaging, carefully
lay machine on it's
back to remove the
polystyrene base
from the bottom.
Unscrew the three
bolts with the sup-
plied spanner.
20
Cotton
Maximum
Remove the power
supply cable and the
hose from the hose
holders on the rear of
the appliance.
Slide out the relevant
plastic spacers.
Cold water
7 kg
1000 rpm
Fill the smaller upper hole and the two large
ones with the corresponding plastic plug
caps supplied in the bag containing the in-
struction booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units.
Level the washing
machine by raising or
lowering the feet. The
feet may be tight to
adjust as they incor-
porate a self locking
nut, but the machine
MUST be level and
stable. If necessary,
check the setting with
a spirit level.
www.zanussi.com