Kit Preparation; Kit Assembly - Metra 95-6547B Instrucciones De Instalación

KIT PREPARATION

1. Remove (4) Phillips screws securing the
climate controls, then remove them in
preparation for the following steps.
2. Place the cut template over the factory
dash panel. (Figure A)
3. Scribe the dash panel on the inside
edges of the template to mark for
cutting. (Figure A)
4. Remove the cut template, then cut the
dash panel and remove shaded areas.
(Figure B)
5. Clip the radio trim panel onto the dash
panel and ensure that it seats properly
to the panel. If not, file the panel until it
seats properly.
6. Secure the climate controls back to the
dash panel using the factory screws.
7. Cut the shaded area of the sub-dash
to allow room for the radio assembly.
(Figure C)
Continue to Kit Assembly
(Figure A)
Remove
shaded area
(Figure B)
Remove shaded area
(Figure C)

KIT ASSEMBLY

1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or Axxess.
Test the radio for proper operation.
3. Secure the radio assembly to the dash
using the factory screws.
4. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
REV. 8/4/2021 INST95-6547B
3