Cord Storage - Krups KT4065 Manual De Instrucciones

cafetie?re dahlstrom EU11.qxd:KM 8005 anglais.qxd
• All operations other than cleaning and usual customer maintenance must be performed by an approved
KRUPS service centre.
• Do not use the machine if the power cord or plug is damaged. To avoid any hazard, the power cord must
be replaced by an approved KRUPS service centre.
• Do not put the machine, power cord or plug in water or any other liquid.
• Do not leave the power cord hanging within children's reach.
• The power cord must never be near or in contact with the hot parts of the machine, near a source of heat
or over a sharp edge.
• For your own safety, only use KRUPS accessories and spare parts suited to your machine.
• Do not disconnect the plug from the socket by pulling on the cord.
• All our machines undergo strict quality control. Tests are carried out on machines at random, which
accounts for any traces of use.
• Do not clean the jug with harsh cleansers, steel wool pads, or other abrasive materials.
• Never place your jug or your insulated pot in a microwave oven, in a dishwasher or on a stove top.
• Never put your hand inside the insulated pot.
• Do not use the jug or the insulated pot without the lid.
• Do not leave the empty jug on the hot plate.
• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure
to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not
BEFORE USING YOUR MACHINE FOR THE FIRST TIME
apply.
Remove all packaging.
Remove them before using the appliance. fig. 1
The water filter holder and DuoFilter cartridge are located inside the water tank during shipping.
Fill the water tank up to the max level and do not use coffee, coffee filter or water filter. fig. 6 & 7
Follow the steps below to run a first brew cycle to rinse the system.
To prepare a new DuoFilter first remove it from its plastic covering.
Unhinge the water filter holder, place the filter into the filter holder. fig. 2
Rinse the filter cartridge under tap water for 1 minute.
Firmly press the filter holder into the bottom of the water tank. fig. 3

CORD STORAGE

See page 17 for setting the clock.
location (h) as long as you need. fig.4
Unused cord can be stored inside the coffee maker (h). To insert the unused cord, push it inside the store
MAKING COFFEE
See drawing N° 5 to 13.
1- Open the top lid by pressing the open button (b) and fill the water tank with cold water taking careful note
of the number of cups. Use filtered water if possible.
The water level indicator displays the number of cups by turning from light to dark as the water level rises.
2- Insert the jug or thermal pot (f) after prewarming by rinsing it out with hot water (prewarming the jug will
help keeping coffee hotter) securely in place (e). Be sure the jug sits straight and level on the heating
plate/base (e) before starting the brew cycle.
3- Add paper or permanent filter to the filter holder.
Krups original accessories (according to model):
16
5/03/09 10:35 Page 16
English