cafetie?re dahlstrom EU11.qxd:KM 8005 anglais.qxd
•
#4 paper filters 100-pack. Item #983
•
#4 size gold tone filter. Item #049
4- Add ground coffee to the into the filter holder or to the permanent filter
•
Measure one rounded coffee scoop per (140 ml) cup of water.
Note : Pay attention to max level indicated on the permanent filter.
•
This simple step is critical to the taste of your brewed coffee.
•
See your brewing guide on page 20 for more detail.
5- Close the lid. The machine is ready to brew.
6- For immediate brewing, press the ON/OFF button and the brew cycle will begin.
•
The ON/OFF button will glow red while the machine is brewing and stay lit for
2 hours while the coffee is kept warm on the heating plate.
DURING THE BREW CYCLE STEAM RISES FROM THE TOP OF THE
•
You can turn the machine off at any time by pressing the ON/OFF button again.
MACHINE. BE CAREFUL TO KEEP HANDS AWAY FROM THIS AREA
UNTIL AFTER THE BREW CYCLE IS COMPLETED !
Auto-Off function:
The heating plate will maintain the temperature in the jug for 2 hours after which the machine shuts off
automatically. This is for safety and convenience. The auto-off time can be adjusted to 1, 2 or 3 hours.
See page 17 – Programming the unit.
For best results brew only as much coffee as you will drink within 30-60 minutes.
Pause and Serve feature:
You can remove the jug during the brew cycles to pour an early cup. Keep in mind that this will change the
taste you would normally get from a full pot in a complete cycle.
For models with thermal pot : to ensure maximum heat retention, rinse the thermal pot with hot water
Be sure to replace the jug quickly (less than 20 seconds) to avoid overflow during the brew cycle.
before use, and close the lid by turning clockwise.
Warning :
•
Hot water continues to drip in the filter holder (h) when the jug (f) is removed. The overflow of
coffee and hot water could cause burns.
•
Do not exceed the maximum capacity of the water tank as shown by the water level indicator (g).
•
Place the ground coffee into the paper filter or directly into a permanent filter.
Note : Pay attention to max level indicated on permanent filter.
After use, discard the grounds, and rinse the filter holder under running water.
CURRENT TIME; SETTING THE CLOCK : FIG. 16
When the machine is first plugged in, the clock blinks and ask you for setting the clock.
Press the H and Min buttons to set the time. This will ensure the Auto-On function activates at the proper
time of day.
If you prefer a 24 hour clock or military time you can switch from AM/PM mode by pressing the H and min
buttons simultaneously. The AM/PM symbol will disappear when the clock is running in 24 hour mode.
PROGRAMMING THE UNIT
You can press and hold the buttons to move quickly through the hours or minutes.
Use the PROG button to access 3 programmable functions. The LCD will display a different function for each
17
5/03/09
10:35
Page 17
English