Installation; Ambient Temperature; Before Placing Food In The Appliance; Temperature Control - THOMSON THLR 600 Manual De Instrucciones

INSTALLATION
Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to
direct sunlight nor near a heat source, e.g. a cooker, radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on each side of
the cabinet.
For uneven surfaces, front feet can be aligned.
To install the handle
1. Remove the hole covers from the side of the door.
2. Align the holes of the handle with the ones on the
side of the door.
3. Insert the supplied screws into the holes and fully
tighten them.
4. Insert the supplied screw covers on the handle.
AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 16°C and 43°C (N/ST/T). If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly. If the
ambient temperatures are exceeded for long periods, the temperature in the fridge will rise above 4°C
and food spoilage may occur.
BEFORE PLACING FOOD IN THE APPLIANCE
• Remove all packaging.
• Allow the appliance to run empty for 2 – 3 hours so the compartment can cool to the appropriate
temperature.
• Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.
TEMPERATURE CONTROL
The appliance is controlled with a temperature control knob located at the upper right side of the
appliance.
Adjust the control knob as desired to suit your individual preference.
0 is off setting
1 is warmest setting
7 is coldest setting
0
In the " " position the appliance does not operate (the cooling system is switched off), but power supply
is not interrupted.
6
6