Electrical Connection - Gorenje DK2000P2 Montaje Y Modo De Empleo

10 INSTRUCTION ON MOUNTING AND USE
• If the hood is to be used in the suction version, install the
flange supplied in the kit on the exit hole of the hood (12A
- suction version – also install a fumes discharge tube
of suitable dimensions) instead of the deflector (12F or
12G – filtering version).
• Mount the grease filter and close the steam screen.
Attention! If the hood is to be used in the suction version,
remove, if supplied with the kit, the carbon filter and the
fixing rods (on the back of the grease filter – see relative
paragraph).
If the hood is to be used in the filtering version, check that
the carbon filter is already mounted on the back of the
grease filter or, in its absence, purchase it and install it.
• Install the upper cover with 3 screws (13).
• Installa the chimney (14a) to the bracket (14b) with two
s c r e w s .
• Slide bottom section of the chimney inside the proper
housing on top of the hood.
• Connect the hood to the general electric panel, wait for
about 15 seconds to allow the hood to calibrate the
control panel (the leds of the controls flash) and check
the functioning.

Electrical connection

The electrical tension must correspond to the tension noted
on the label placed inside the cooker hood. Connect the
electrical plug, where provided, to the an easily accessible
outlet in conformity with local standards in force.
Where an electrical plug is not provided (for direct connection
to electrical network) place a standards approved bipolar
switch with an aperture distance of not less than 3mm
(accessible) from the contacts.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE). By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance may not
be treated as household waste. Instead it shall be handed over
to the applicable collection point for the recycling of electrical and
electronic equipment. Disposal must be carried out in accordance
with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and
recycling of this product, please contact your local city office,
your household waste disposal service or the shop where you
purchased the product.
GB