Activating/Deactivating The Pre-Flush Via The Membrane Keypad (Mains Version Only); Setting The Presence Detection Via The Membrane Keypad - DURAVIT DuraSystem WD5006 Manual De Uso

Activating/deactivating the pre-flush via the membrane keypad (mains version only)
You can activate/deactivate the pre-flush via the membrane keypad.
range
time

Setting the presence detection via the membrane keypad

You can increase or decrease the presence detection range by pressing "range+" or
"range-" on the membrane keypad (see table 2: Presence detection).
range
time
The status LED flashes 5 times in succession if you have reached the maximum or
minimum range.
You must set the minimum range for urinals with covers
(see table 2: Presence detection).
> Press the "time+" and "range+" setting
buttons simultaneously for 3 seconds.
The status LED lights up on the membrane
keypad for 3 seconds.
activated. If the status LED flashes, the
pre-flush is deactivated.
> Press the "range+" setting button if you
want to increase the range.
> Press the "range-" setting button if you
want to decrease the range.
The status LED flashes twice each time you
press the button. The range is increased/
decreased by the corresponding steps.
The pre-flush is
41