Activating/Deactivating The Hygiene Flush; Retrieving/Adjusting The Hygiene Flush Settings - DURAVIT DuraSystem WD5006 Manual De Uso

Retrieving/adjusting the hygiene flush settings
You can retrieve and adjust the set number of flushes ("Hygiene flush (flush packag-
es)") and the duration between the intervals ("Hygiene flush (time interval)") (see 1.2
Remote control).
> Press the "Hygiene flush (settings)" preselection button on your remote control.
The status LED lights up for 5 seconds on the control panel. You can make settings
within these 5 seconds.
> Press the "Hygiene flush (flush packages)" or "Hygiene flush (time interval)" button
on your remote control.
The current setting is displayed on the control panel approximately 1 second after
pressing the button: the status LED flashes between 1 and 10 times in ascending order
according to the level that is set (see table 4: Setting the hygiene flush).
The settings are increased/decreased with each additional press of the button.
> Press the "+" setting button if you want to increase the settings.
> Press the "-" setting button if you want to decrease the settings.
The status LED flashes each time you press the button. The settings are increased/
decreased by the corresponding steps.
Hygiene flush
Number of flushes
Interval time
Table 4: Setting the hygiene flush
The status LED flashes on the control panel in "Hygiene flush (settings)" mode to dis-
play the current settings of the hygiene flush. If the LED flashes 5 times, for example,
after pressing the "Hygiene flush (flush packages)" button, the number of flushes is
set to 5. If the LED flashes 5 times after pressing the "Hygiene flush (time interval)"
button, the interval time is set to 120 h.
Factory settings
Deactivated
1
24 h
Setting range
Activated/deactivated
1 to 10 (10 steps)
24 h, 48 h, 72 h ... up to 240
h (10 steps)
first
45