Pur Line PANEL S Serie Manual De Usuario página 17

EN
3. The hook racks are pre-assembled on the back of the heater, hang the top two hook racks on the screws. Mark
the two bottom hook racks' position on the wall and take away the heater, then drill bottom two holes(Φ8) on
the wall and put expansion screw's plastic cover in the holes.
4. Hang the heater on the wall and put the expansion screws in the bottom two holes.
WARNING ! Before starting the appliance, make sure that it is properly fixed to the wall. If the device is not level,
problems may occur.
FEET ASSEMBLY
1. Place the feet on the lower part of the body.
2. Fix each foot with the 4 screws.
15