Setting The Date And Time - Italiana Camini IDROPOINT Guía De Instalación, Uso Y Mantenimiento

SCREW LOADING (only if the stove is completely without pellets)
To load the screw, enter the MENU by pressing the key
load" appears on the display.
Press the key to confirm, and then the key
This operation must only be carried out when the stove is off and completely cold.
Note: during this phase, the smoke extractor fan will remain on.
STAND-BY FUNCTION
In this mode, the stove will go off when the temperature of the environment is 0.5°C higher than that requested, after a set time of
10 minutes (which can be changed by the TAC during installation).
The message "GO STBY" will appear on the display, indicating the minutes remaining before switch-off.
This function is available in both 'AUTOMATIC' or 'MANUAL' mode and in the case of an external thermostat.
If the environmental temperature falls to 2°C below the set threshold, the stove will start up again (setting modifiable by the TAC
during installation).
To activate the function, press the key
until the message "M4 stand by" appears on the display, then confirm by pressing the key
key
Press the key to select "ON", then confirm by pressing the key
To quit the menu "M4 stand by", press the key

SETTING THE DATE AND TIME

Press the key for about 2 second; the message "M1 set clock" will appear on the display; then confirm by pressing the key
The following data will appear in sequence: Day of the week, hour, minutes, day, month, year; these can be changed by pressing
the key or the key . To confirm, press the key
To quit the menu "M1 set clock", press the key
EXTERNAL THERMOSTAT
This must be connected by the blue wire (optional code 640560) to the serial port positioned on the back of the stove; it must have
a clean, normally open contact (e.g. in the case of an environmental thermostat):
- Open contact = Environmental temperature reached
- Closed contact = Environmental temperature not reached
To select 'E-T' (external thermostat) mode, press the key
perature until the message 'E-T' (external thermostat) appears on the display (below 6°).
Note: When the stove is off, the external thermostat cannot switch the stove on or off.
If you want to switch the stove on or off outside the set time or outside the 'E-T' (external thermostat) setting, you must always
do so using the key .
CHRONO-THERMOSTAT FOR DAILY/WEEKLY PROGRAMMING
There are 3 types of programming (daily, weekly, weekend), each of which is independent of the others and thus many combina-
tions are possible according to the user's requirements (time programming is in 10 minute steps).
Press the key for 2 seconds; the message "M1 set clock" will appear on the display (and the LED will go out).
Press the key until the message "M2 set chrono" appears on the display; confirm by pressing the key
To visualise the 3 programming modes (daily, weekly, weekend) press the key
INSTRUCTIONS FOR USE
for 2 seconds; then press the key
to activate the function.
for about 3 seconds; the message "M1 set clock" will appear on the display; press the
for about 6 seconds.
.
for about 6 seconds.
- 213
.
(the LED will light up). Pressing the key
or the key
-
until the message "M5 first
.
will lower the tem-
.
, and confirm by pressing the key
.