Indication Of Battery Charge Status; Fastening Tool - Hilti GX 2 Manual De Instrucciones

Status
One LED blinks red.

3.11 Indication of battery charge status

After pressing a battery release button, the display shows the status of the battery and
the fastening tool.
Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED blinks green.
One LED blinks green.
4 Technical data

4.1 Fastening tool

Weight (empty)
Application temperature, ambient temperature
Maximum fastener length
Fastener diameter
Compression stroke
Magazine capacity in strips of 10 nails (Maga-
zine capacity)
Maximum fastener driving frequency (Fasten-
ers per hour)
5 Loading the fastening tool
5.1 Equipment required for driving nails
Nails are fed through the magazine in strip form (ready-to-use strips of nails).
5.2 Loading the magazine
1. Pull the nail pusher back until it engages.
2. Slide the nail strips into the magazine as far as they will go.
Meaning
• No gas can or the wrong type of gas
can is present in the fastening tool.
Meaning
• Charge status is 75 % to 100 %.
• Charge status is 50 % to 75 %.
• Charge status is 25 % to 50 %.
• Charge status is 10 % to 25 %.
• Charge status is below 10 %. The
fastening tool is ready for operation.
• The fastening tool is overloaded or
overheated and thus not ready for
operation.
8.6 lb
(3.9 kg)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
1.5 in
(39 mm)
• 0.10 in (2.6 mm)
• 0.12 in (3.0 mm)
1.6 in
(40 mm)
1 ... 4
1,200
7