Support Leg; Indication Of Gas Can Status - Hilti GX 2 Manual De Instrucciones

Status
«+»
«­»
«EJECT»

3.7 Support leg

On an even working surface, the support leg makes it easier to hold the fastening tool
perpendicular as attention then only has to be paid to lateral alignment. On an uneven or
undulating surface it may be necessary to remove the support leg in order to allow the
fastener guide to be held perpendicular to the working surface.
3.8 Belt hook
The belt hook can be extended in three stages.
Status
Position 1
Position 2
Position 3
3.9 Gas can
Note
Observe the safety instructions provided with the gas can!
In order to operate the fastening tool, the gas can must be inserted in the gas can
compartment.
The gas can status can be read from the LED display after pressing the ‚GAS' button.
The gas can must be removed before breaks between working, before maintenance and
before transporting or storing the fastening tool.

3.10 Indication of gas can status

After pressing the ‚GAS' button, the LED display indicates the status of the gas can.
Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED blinks green.
One LED blinks green.
6
Meaning
• Standard fastener driving depth
• Reduced fastener driving depth
• Fastener guide release
Meaning
• Position for attaching to a waist belt
• Position for attaching to ladders,
scaffolds, platforms, etc.
• Belt hook removed
Meaning
• The level is between 100 % and 75 %.
• The level is between 75 % and 50 %.
• The level is between 50 % and 25 %.
• The level is between 25 % and 10 %.
• Level is below 10 %. Replacement of
the gas can is recommended.
• The gas can is empty or is malfunc-
tioning. Replacement of the gas can is
recommended.
Note
Even when the level is indicated as
"empty", the gas can, for technical
reasons, still contains a little gas.