Air Filter System; Cleaning The Air Filter - Stihl MS 210 Manual De Instrucciones

Chain type Pitch
Picco 3/8" P
Rapid 1/4"
Rapid 3/8"; 0.325" 0.24"
Rapid 0.404"
If groove depth is less than specified:
N
Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C

Air Filter System

Minimum
groove
depth
The air filter system can be adapted to
0.20"
suit different operating conditions by
(5.0 mm)
installing a choice of filters. Changing
0.16"
the filter is quick and simple.
(4.0 mm)
The saw comes standard with either a
fabric filter or a fleece filter.
(6.0 mm)
0.28"
(7.0 mm)
Fabric filter
For normal operating conditions and
winter operation.
Fleece filter
For dry and very dusty work areas.

Cleaning the Air Filter

If there is a noticeable loss of engine
power
N Squeeze the throttle trigger lockout
and move the Master Control lever
to l (cold start).
N Turn the knob 90° to the left.
N Lift off the carburetor box cover
vertically.
N Always replace damaged filters.
N Clean away loose dirt from around
the filter.
1
N Place fingers behind the air filter (1),
press thumbs against the housing
and swing the filter in direction of
rear handle.
English
41